How do I connect my AirTies 4920 to my modem?
On the Air 4920: Hold the WPS button on the front of the device for 2 seconds. The device will now connect to the router and copy its network name/SSID and password from the 5 Ghz network. After pairing, wait for about 30 seconds for both the router and the repeater to come online.
How do I setup my Airi wifi extender?
EASY SETUP: ACCESS POINT
- Position one Air 4920 next to your router and connect the two using the enclosed Ethernet.
- Connect the Air 4920 device to the mains and press the power switch.
- Wait until both 5 GHz and 2.4 GHz LEDs are solid green This may take up to 3 minutes.
How do I reset my AirTies 4920?
How to factory reset (hard reset) AirTies Air 4920 :
- When the router is on, press the button reset and hold for 30 seconds.
- While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds.
How do you connect a device to a Wi-Fi extender?
To set up your extender:
- Plug in your extender.
- Connect your computer or mobile device to the extender’s WiFi network.
- Launch a web browser and enter mywifiext.net or 192.168.
- Click or tap NEW EXTENDER SETUP.
- Choose your extender’s admin credentials.
- Select and answer two security questions from the drop-down menus.
How do I reset my AirTies?
See also Extending your AirTies mesh network with an additional device….To reset a device to factory default:
- Use the end of a metal paper clip, plastic toothpick, or similar.
- Push this pointy object down the hole marked “RESET” on the back of the access point and hold it for 5 seconds.
How do I add a device to my Extender?
To connect devices to your extender: Turn ON the extender and connect all the devices to your extender network. Make sure that the router LED link remains lit. Launch a web browser and type: www.mywifiext.net or www.mywifiext.com in the address bar. A pop up window will appear asking for a User Name and Password.
How do I reset my AirTies modem?
How do I set up AT AirTies?
Place your extender close to your Wi-Fi gateway. Press the WPS button on the front of the gateway, then press the WPS button on the extender. The 5GHz and 2.4GHz lights will blink and then turn solid green when they successfully pair. Move the Wi-Fi extender to your desired location.
How do I connect my Wi-Fi extender without WPS?
If your router doesn’t support WPS, go to ‘Method 2 – Without WPS button’ opposite. 1 Plug the extender into a power socket near your broadband wireless router (e.g. in the same room). Check the extender On/Off button on the top is switched on. Wait 20 seconds for the extender to boot up.
How do I know if I am connected to Wi-Fi extender?
Go to Settings > Status to check the internet status of your extender. If everything is OK as shown below, your extender is successfully connected to your router. Connect your devices to the extender wirelessly or via an Ethernet cable.
How do I reconnect my AT WiFi extender?
To get it to sync:
- Place your extender close to your Wi-Fi gateway.
- Press the WPS button on the front of the gateway, then press the WPS button on the extender. The 5GHz and 2.4GHz lights will blink and then turn solid green when they successfully pair.
- Move the Wi-Fi extender to your desired location.