How does a transistor act as a closed switch?
If a positive signal applied at the input terminal then it acts like a closed switch. When the transistor operating as switch, in the cut off region the current through the transistor is zero and voltage across it is maximum, and in the saturation region the transistor current is maximum and voltage across is zero.
How does a single-pole single throw transistor work?
Then the transistor operates as a “single-pole single-throw” (SPST) solid state switch. With a zero signal applied to the Base of the transistor it turns “OFF” acting like an open switch and zero collector current flows.
Why do we use multiple switching transistors in bipolar transistors?
Sometimes the DC current gain of the bipolar transistor is too low to directly switch the load current or voltage, so multiple switching transistors are used. Here, one small input transistor is used to switch “ON” or “OFF” a much larger current handling output transistor.
What is the power loss in a transistor switch?
When the transistor operating as switch, in the cut off region the current through the transistor is zero and voltage across it is maximum, and in the saturation region the transistor current is maximum and voltage across is zero. Therefore, both the on – state and off – state power loss is zero in the transistor switch.
Why is a transistor switched to be fully-on?
Here the transistor will be biased so that the maximum amount of base current is applied, resulting in maximum collector current resulting in the minimum collector emitter voltage drop which results in the depletion layer being as small as possible and maximum current flowing through the transistor. Therefore the transistor is switched “Fully-ON”.
Why do we use transistor switches instead of logic gates?
Some output devices, such as LED’s only require a few milliamps at logic level DC voltages and can therefore be driven directly by the output of a logic gate. However, high power devices such as motors, solenoids or lamps, often require more power than that supplied by an ordinary logic gate so transistor switches are used.