When laying vinyl plank where do you start?

Start laying the flooring along one wall, working row by row. GripSure vinyl plank flooring has adhesive strips to connect the planks together. Again, start by laying the first row along the wall. Glue-down vinyl plank flooring requires you to apply the adhesive to the subfloor before laying the planks.

Table of Contents

Do you need subfloor under vinyl plank?

If you’re laying the LVP over an existing cushion-backed vinyl floor or a below-grade tile floor, then you won’t need to use an underlayment. However, you’ll want to use one in every other application including covering existing hardwood floors, vinyl flooring that isn’t cushioned, and concrete floors.

Where should I start my first row of laminate flooring?

Begin the first row of flooring by placing the planks with the tongue side facing the wall. Install the second plank next to the first by aligning the tongue into the groove and press the plank down to snap it in place. When you come to the end of the first row, cut the length of plank needed to complete the row.

Do you have to cut the tongue of the first row of vinyl plank flooring?

Place the first plank with the tongue side towards the wall, being sure to allow 1/8″ for expansion. We recommend cutting off the tongue on this first row to avoid any problem with the expansion gap.

How do you get the first row of the floor straight?

Snap a chalk line down the middle, measure from that line to within a few inches of the starting wall, and snap a second line parallel to the first. Align your first piece with the second line. Then every couple of rows, measure to make sure you are still parallel with the first chalk line.

How do you start the first row of laminate floor if the wall is not straight?

How to Start the First Row on Laminate Floor if the Wall is Not Straight

Step 1: Mark the Expansion Gap.
Step 2: Determine Out-of-Square Measurement.
Step 3: Begin at the Starting Wall.
Step 4: Mark Half of Out-of-Square Measurement.
Step 5: Angle and Intersect Chalk Lines.
Step 6: Cut Boards at Markings.

Does it matter where you start laying laminate flooring?

We recommend starting in the left corner of the longest wall in the room and to install the planks in the same direction as the main light source (e.g. the main window). Planks are always installed from left to right.

How do you prepare a subfloor for vinyl plank flooring?

5 Simple Steps to Prepare a Subfloor for Vinyl Flooring

Step 1: Test the Floor for Moisture.
Step 2: Repair Holes and Cracks.
Step 3: Sand Down Bumpy Areas.
Step 4: Clean the Subfloor.
Step 5: Install Underlayment (Optional)

Can you put vinyl plank flooring over plywood subfloor?

Can I install vinyl flooring over wood, plywood, particleboard or chipboard? You can install vinyl over wood floors if you put a plywood subfloor on top of it. Do not install glue down or peel and stick products over particleboard, chipboard or any form of embossed floor.