How do you clear the error code on a Maytag Bravos washer?
Write Down The Error Code! Then press PAUSE/CANCEL once to clear the error code and try to start a new cycle. If code appears again put it through an automatic diagnostic cycle while you enjoy a nice soothing cup of tea.
How do I fix the HC error on my Samsung washing machine?
Samsung malfunction HE, HC or CE If so, there is a fault with the washing temperature sensor. This happens when the water temperature in the drain is higher than 50 ˚C. Turn off the washing machine and remove it from the power for 30 minutes. Reconnect the device and see if the error code is missing.
How do I reset my Maytag Bravos XL washer to factory settings?
Turn the Cycle Selector knob counterclockwise or left (all the way around) once. Next, turn the knob clockwise (right) – Go three clicks clockwise (count one… two… three as you turn the dial clockwise).
How do I reset my Maytag error code?
How do I clear the error code on my Maytag washer? To clear the error code on your washing machine, you have to press the pause/ cancel button twice and the power button once. If still, code is displayed, unplug the machine for a minute.
What does HC mean on a washing machine?
hot and cold hoses reversed
If HC (hot and cold hoses reversed) appears in display, it means the hot and cold inlet hoses have been installed incorrectly. This code will appear at the end of the wash cycle to indicate that the cold water hose is connected to the hot water inlet, and the hot water hose is connected to the cold water inlet.
How do I clear the HC error on my Samsung dryer?
Heating errors (HC, hE, HC4, 1 HC) The most common cause is a clogged lint screen or vent system trapping heat in the dryer. Clean the lint screen, vent system, or both to correct the error.
How do you run diagnostics on a Maytag Bravos XL washer?
Console & Indicator Diagnostic Test Mode
- The washing machine should be in standby (off) mode.
- Press and release the following buttons within 4 seconds.
- if successful “dt” should display on the washing machines indicator.
- Whithin 5 seconds press “Start” all indicator lights should come on and 88 should be displayed.
Why does my Bravos XL washer keep stopping?
If the door lock is defective, the washer may stop mid cycle. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.
What are the codes for a Maytag washer?
Error Codes in your Maytag Top Load Washer:
| Error code | Error |
|---|---|
| Ofb | The washer load is out of balance. |
| OL | The washer load too large. |
| PF | The wash cycle was interrupted by a power failure. |
| Sud | There are excessive suds in washer. |
What does HC mean on my Kenmore washer?
HC. Error code HC occurs on Kenmore Elite Oasis domestic washing machine model numbers 110.2703, 110.2704, 110.2705 and 110.2715. The error code indicates that the hot and cold inlet hoses have been reversed, meaning that the washer is receiving hot water when it needs cold and vice versa.