Menu Close

What is the principle of Urisys 1100 urine analyzer?

What is the principle of Urisys 1100 urine analyzer?

Overview. The Urisys 1100 system is a reflectance photometer designed to read and evaluate the urine test strips Combur10Test UX from Roche Diagnostics. It reads the strips under standardized conditions, saves the results to memory and outputs them via its own inbuilt printer and/or serial interface.

What is Urisys?

The Urisys 1100® Urine Analyzer is a reflectance photometer. It reads the urine test strips under standardized condi- tions, saves the results to memory and outputs them via its own built-in printer and/or serial interface.

How do I calibrate my Urisys 1100?

If the Urisys 1100® analyzer is in Ready-to- Measure mode, press the left function key to select “Calibr.” Next, the message “START CALIBRATION” is displayed. 2 Place the calibration strip, with pads facing upward, on the test strip tray. About 2 mm of strip must be held under the clip. 3 Press the START button.

What is urine analyzer?

A urine analyser is a device used in the clinical setting to perform automatic urine testing. The units can detect and quantify a number of analytes including bilirubin, protein, glucose and red blood cells.

How do you read urine lab results?

Normal values are as follows:

  1. Color – Yellow (light/pale to dark/deep amber)
  2. Clarity/turbidity – Clear or cloudy.
  3. pH – 4.5-8.
  4. Specific gravity – 1.005-1.025.
  5. Glucose – ≤130 mg/d.
  6. Ketones – None.
  7. Nitrites – Negative.
  8. Leukocyte esterase – Negative.

What can be detected in urine test?

A dipstick test checks for:

  • Acidity (pH). The pH level indicates the amount of acid in urine.
  • Concentration. A measure of concentration shows how concentrated the particles are in your urine.
  • Protein. Low levels of protein in urine are typical.
  • Sugar.
  • Ketones.
  • Bilirubin.
  • Evidence of infection.
  • Blood.

How often should you clean the white calibration bar?

Inspect the white calibration bar once per day- Clean with a cotton-tipped swab and distilled water-moistened kimwipe. 3. Inspect the white calibration bar once per day. Clean with a cotton-tipped swab and distilled water only if dirty.