Menu Close

How can I connect my tp link router to 3G modem?

Admin

How can I connect my tp link router to 3G modem?

Note: To use the 3G function, you should first insert your 3G USB modem on the USB port of the modem router.

  1. Open the web browser and type the IP address of the device in the address bar (default is 192.168.
  2. Type the username and password in the login page, the default username and password are.

What is 3G 4G Router Mode TP Link?

In Wireless Router mode, you can use a 3G/4G network as a backup solution for internet access. When 3G/4G Backup enabled, your router will connect to the 3G/4G network when the original network service fails.

How do I configure my TP Link TL MR3420 router?

TP-LINK MR3420

  1. Log into your router by typing 192.168.1.1.
  2. Click on NETWORK in the left menu.
  3. Click WAN Settings in the submenu (page 33)
  4. Locate the Primary DNS and Secondary DNS fields and use the addresses 208.67.222.222 and 208.67.220.220.
  5. Click SAVE and the device will reboot.

How do I access my TL-MR3420?

How to configure Access Control on 3G/4G Wireless Router TL-MR3420 (new logo)

  1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
  2. Go to Advanced > Security > Access Control.
  3. Enable Access Control.
  4. Select the access mode to either block (recommended) or allow the device(s) in the list.

How do I reset my TL-MR3420?

To reset the TP-LINK TL-MR3420 V2 to its default settings, you have to do the following steps:

  1. Switch on router.
  2. For at least 5 seconds, press the WPS/RESET button.
  3. Device is automatically restarted.
  4. Restoration of standard settings is finished.

How can I use 3G dongle as Wi-Fi?

How to configure Data card/USB dongle as a Wifi Router

  1. Connect the 3G dongle in USB slot.
  2. Connect the router with LAN wire that you get with the router.
  3. You can see router configuration page and specify your ISP provider (example: Tata photon)
  4. Enter required fields and set a password.

How do I setup my 3G 4G hub?

Plug it into a power socket and wait a few minutes for it to set itself up. You can then connect your phone, tablet, whatever you like, and start browsing. To get the best experience, it’s worth turning your hub to face from one direction to another. You can try it in a few different locations too.

How do I reset my tp-link MR3420?

How do I setup my tp-link router without Ethernet cable?

Power on your router and computer first and then modem.

  1. Log into the router’s web-based management page.
  2. Configure WAN Connection Type.
  3. Enter your PPPoE username and password which are provided by your ISP.
  4. Click Save to save your settings, then the router will connect to Internet after a while.