How do you activate a bark collar?
Use a large coin to turn the battery clockwise until the arrow lines up with the lock symbol on the housing. This turns the Bark Control Collar on. To remove the battery, turn the battery counter- clockwise using a large coin.
How do you charge an Innotek dog collar?
Your collar receiver is rechargeable and can be charged by placing the collar on the charging cradle located on top of your wall-mount transmitter. The collar strap should fit snugly towards the top of your dog’s neck with the collar receiver box on the bottom of the neck.
How do I change the battery in my Innotek dog collar?
Twist the battery cover, located on the back of the receiver box between the two contact probes, counter clockwise. Remove the cap and set it aside. Tilt the receiver box until the two batteries fall out. Replace them with two new 3-volt lithium coin cell batteries.
How do you reset a free spirit shock collar?
Turn the training collar off. Press and hold the on/off button. The LED light will turn on, then off in 4-5 seconds.
How do I know if my bark collar is working?
How to test your Bark Collar
- Press and release the power button to power the collar on.
- Watch for the green light to blink twice, then hold the power button. Continue to hold the power button through the red light.
- Release the button when the light turns blue to set the collar into test mode.
How do you know if a bark collar is working?
Hold the collar probes against the wire on the test light tool. The collar will test all 15 stimulation levels, causing the tool to flash at each level. Important: The test light tool will have a dim flash when testing low levels. If a flash is not seen, hold the tool on the collar until higher levels are being tested.
How do you pair a free spirit dog collar?
To pair the receiver collar to your handheld, first begin with the collar powered off. Then, press and hold the power button on the collar and the light on the collar should come on; continue to hold the button until this light goes out. Once that happens, release the button on the collar and press …more.
Is Innotek and PetSafe the same company?
Innotek is now part of the PetSafe family!
How do you reset a dog shock collar?
Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5 times. You may need to hold both units 2-3 feet from each other before this occurs. Once the Receiver Indicator Light has flashed 5 times, the Collar Receiver has been reset and will begin flashing as normal.
Do bark collars have settings?
Get into the habit of checking the settings and making sure the collar works before putting it on your dog. Sometimes the settings get changed, so always check before putting it on your dog. Spending the 2 seconds to check the settings beats having your dog get shocked way stronger than you want.
How long should you leave a bark collar on?
Left on for long periods, a bark collar could irritate your dog’s skin, so it’s recommended you leave the bark collar on your pet for no more than 12 consecutive hours. For your dog’s comfort, it’s best to remove the collar while he’s indoors.
What happened to Innotek?
Why is my shock collar not shocking my dog?
If BOTH contact points are not touching the dog’s skin, the dog will not perceive any sensation at all. This happens because the collar is on the dog too loose. When you are new to using an e-collar be aware that the fit is far snugger than any other collar you have likely put on your dog.