What is the axle width?
Wheel track, track width or simply track refers to the distance between the centerline of two wheels on the same axle. In the case of an axle with dual wheels, the centerline of the dual wheel assembly is used for the wheel track specification. Axle and wheel track are commonly measured in millimetres or inches.
How wide is a Ford 8.8 axle?
7] From the factory, 8.8s use 1330- or 1310-series U-joints. This is the companion flange where the yoke bolts. The 1330 has a 3316-inch width for the U-joint, and the 1310 has a 358-inch width. The 1330 is usually found in Ford trucks.
How wide is a Ford 9-inch?
These axles are 65 inches wide from wheel mounting surface to wheel mounting surface (a 68-inch-wide E-series van version is also common), feature the legendary 9-inch diameter ring gear, large Timken set 20 axle bearings, semi-floating 28- or 31-spline axleshafts, drum brakes, and a 5-on-5.5 lug pattern.
How wide is a Ford 8.8 rear axle?
How wide is stock 8.8 rear end?
How To Spot, Build, And Swap In the Ford 8.8 Mustang Rearend.
| Vehicle Application | Axle Width (inches) |
|---|---|
| ’86-’93 Ford Mustang 8.8 | 59 11/44 |
| FORD | |
| ’65-’66 Mustang | 57 11/44 |
| ’67-’70 Mustang 8.0 | 59 51/48 |
How wide is a Ford 8.8 rear end?
Can you shorten axles?
If your car has already been blessed with a stout housing and simply needs a trim, cutting down the axles and rearend housing can be a cost-efficient way to fit those asphalt crayons out back.
What is a 9 Ford rear end?
The Ford 9-inch rear end, so named because of its 9-inch ring gear diameter, was manufactured from 1957 to 1987 by the Ford Motor Company and installed in some intermediate and most full-size Ford, Lincoln, and Mercury passenger cars, F-Series ½-ton trucks, and Econoline vans.
What is a Ford 9 inch axle?
The Ford 9 inch housing is a semi-floating, drop-out axle. Because of their strength, you’ll see these 9 inch rear ends used in just about every make of car, truck, and customs. Ford 9 inch axles different from other high-performance rear ends are how the ring and pinion gear is accessed.
What kind of rear axle does Dodge use?
A completely different ZF axle with little aftermarket support so far. The Chrysler 9.25″ rear axle is commonly found in Dodge cars and trucks. They use a 9.25″ ring gear and run 31 spline axle shafts.
What’s the Chrysler rear axle size?
The Chrysler 9.25″ rear axle is commonly found in Dodge cars and trucks. They use a 9.25″ ring gear and run 31 spline axle shafts. A front version of this axle was offered as well, however, it used reverse rotation gears and 33 spline axle shafts to the internal parts are not compatible.
What years did Ford make the 9 inch rear end?
If you have QUESTIONS about Ford 9″ Rear Ends, please visit our Forum. 1967-1973 medium and big block Mustangs and Cougars 1966-1971 Fairlanes, Torinos, Montegos, Comets, and other Ford intermediates with big blocks.