How do you program a Kwikset lock 916?

Make sure the door is open. Press the Program button once.
Press checkmark symbol once.
Enter user code. A total of 16 user codes may be programmed. Each user code must be a unique code between 4 and 8 digits.
Press lock symbol once.

How do I change the master code on a Kwikset 916?

Press and HOLD the Program button until the Check mark symbol illuminates (about 5seconds).

Table of Contents

Press Checkmark symbol once.
Enter new Master Code.
Press Lock symbol once.
Re-enter Master Code.
Press Lock symbol once.
If programming is successful, the Checkmark will illuminate and you will hear one beep.

Does Kwikset 916 have an app?

Smartcode 916 does not have it’s own Kwikset app. A smart hub connection will always be needed for locking/unlocking operations either in the Bluetooth range or remotely while you are away from home.

How do I turn off auto lock on Kwikset 916?

Located on the interior side of the lock there are 4 switches. Switch #2 if in the up position this will enable the 30 second auto locking feature and if the switch is in the down position this will disable the auto locking feature.

How do I program my Kwikset SmartCode?

How do I program my SmartCode 913 lock?

Open the door.
Remove battery cover.
Press the program button once.
Enter new user code.
Press lock button.
If programming is successful the keypad will flash green once, and you will hear one beep.

Where is the program button on Kwikset lock?

While the door is open, press the “Program” keypad button located on the interior side of the door. Enter a four to eight digit security code that you can easily remember on the outside electronic lock keypad.

Does Kwikset 916 work with Alexa?

Kwikset 99160-002 SmartCode 916 Touchscreen Electronic Deadbolt Featuring SmartKey, Works with Alexa via SmartThings or Wink, Satin Nickel. “Alexa, lock the door.”

How do I reprogram my Kwikset SmartCode?

Hold the button continuously for 30 seconds until you hear a beeping sound and see the status LED flashing red. Press the program button once again until you see the status LED flashing green and hear two beeping sounds. The Kwikset SmartCode deadbolt has now been reset and ready to be set up again.