Is Ruger SR-556 a mil-spec?
The Ruger SR-556 is equipped with a six-position telescoping M4-style buttstock that houses a Mil-Spec buffer and spring.
How accurate is the Ruger AR-556?
When taken to the range, the AR-556 excelled from zero-to-one-hundred yards (typical for a carbine sized rifle). At one hundred yards, the AR-556 shot an average of 1.51-inch five-shot groups. In a self-defense situation, accuracy is critical. The AR-556 provides just that.
Is piston driven AR better?
Direct impingement ARs tend to be more accurate at a more affordable price while being easier to carry. On the other hand, piston-driven systems offer more reliability, while running cleaner and cooler. Ultimately, it’s up to you to decide.
Are Ruger AR-556 barrels chrome lined?
The barrel is made of chromoly steel, and it is not chrome lined. The barrel is threaded and topped with a Ruger flash suppressor.
What is the range of a Ruger AR-556?
When taken to the range, the AR-556 excelled from zero-to-one-hundred yards (typical for a carbine sized rifle). At one hundred yards, the AR-556 shot an average of 1.51-inch five-shot groups.
What is the accuracy of the SR-556 takedown?
The SR-556 Takedown’s accuracy with 5.56mm ammunition was very good. Using the iron sights, sub-2-inch groups at 100 yards were fairly common. I tested loads with bullets weighing 53 to 62 grains, and all were solid performers.
What kind of piston does a Ruger SR-556 takedown have?
The SR-556 Takedown uses a two-stage gas piston with a regulator that the shooter can use to tune the rifle to different ammunition and conditions. Ruger chrome plates the piston system.
How do I remove the barrel from the SR-556 takedown?
The SR-556 Takedown has a standard lower receiver with a Magpul MOE SL buttstock. Pulling on the locking tabs below the forend side rails allows you to turn the barrel assembly and slide it out.
What kind of case does a Ruger SR 556 come in?
The SR-556 Takedown comes in a soft case that can hold the disassembled rifle, mags, ammo and other gear. The rifle comes with flip-up front and rear sights, and Ruger recommends making all adjustments on the front sight to maintain zero after barrel swaps.