How do I create a user code in Vista-20P?

To add a secondary user code, enter the 4 digit master code followed by the number 8, plus the 2 digit user number (any number from 03 or higher) plus the 4 digit user code, i.e., [1234] + [8] + [03] + [5678]. The system will beep to confirm the user was added. Each user code can be assigned an authority level.

Table of Contents

How do I program my Honeywell Vista 20P?

The first step when programming a Vista-20P is to enter programming mode. You can do this by entering your [Installer Code] + [8] + [00]. The default installer code on a Honeywell Vista-20P is 4112. If you have lost your installer code, you can alternatively use the backdoor method to get into programming.

Where is the master code on Vista 20P?

[Installer Code] + [8] + [02] + [New Master Code]

Note that the “02” part signifies that you are selecting the user slot 02, which is associated with the Master Code.
If you do not know your Installer Code, then you will need to use the backdoor method to get into programming.

How do I change my user code in Vista 128?

Complete the following steps to change the Master Code on a VISTA 128BPT:

Signify a code command. On your keypad (preferably an alphanumeric keypad), enter in the following:
Identify the user number.
Provide the new code.
Do not add new user.
Confirm the new code.

Where is the master code on Vista-20P?

How do I reset my Honeywell Security code?

You can’t “reset” the installer code but if you then press *20 and enter a 4-digit code that isn’t currently programmed as any other code for the panel, it should beep to confirm that you set the installer code to that new 4-digit code. You can then press *99 to exit the programming mode.

How do I program my Vista 128?

Users must enter the programming mode to change the installer code on the Honeywell Vista 128BPT control panel. From the Vista keypad, enter into the programming mode by entering the existing 4 digit Installer Code + [8] + [0] + [0] + [0].

How do I change master code Vista 20p with installer code?

To change the code, enter in the following command:

[Current Master Code] + [8] + [02] + [New Master Code] + [New Master Code Again]
The keypad will produce a long tone to confirm that the code has been successfully changed.
Test the code.
[New Master Code] + [3]
The system should begin to arm.
[New Master Code] + [1]