How do you open the filter on a Fisher and Paykel dryer?
To clean the filter:
- Open the dryer door.
- Remove the lint filter by pulling it up and out of the filter slot. Open it out and wipe the surfaces clean with your hand.
- Close the lint filter and place it back in the opening. Ensure the filter is fitted correctly back in place before operating the dryer.
Where is the filter on a Fisher and Paykel dryer?
The lint filter is located in the door opening (at the bottom). There is a warning light that will flash at the beginning of every cycle to remind you to clean the filter.
How do I reset my Fisher and Paykel condenser dryer?
Press and hold the ‘Keylock’ and ‘Delicate’ buttons together for three seconds. Your dryer will now be reset to the default settings.
Where is the filter on a dryer?
The up-front dryer lint filter is conveniently located in the front of the dryer and is easy to remove for cleaning. We recommend that the dryer lint filter be cleaned after each use of the dryer. To remove the filter: Grab the filter at the top, center and pull up.
How do you unclog a dryer lint trap?
Remove the lint screen, and use a vacuum to remove any small bits of leftover lint. Take the lint trap screen to the sink, and wash it with warm soap and water. While the lint trap dries, use your vacuum to clean the slot the lint trap slides into. Use a long, narrow vacuum extension to reach as far down as possible.
How do you clean the filter on a Fisher and Paykel washing machine top loader?
To clean the filter:
- Turn the power off and unplug the machine.
- Use a coin to open the filter cover.
- Unhook the pump outlet hose and pull it out (about 150mm).
- After the draining process is complete, replace the plug into the hose and refit the hose back into the housing.
- Remove the filter by turning anti-clockwise.
Why does my dryer keep saying clean filter?
Some dryers with electronic controls have a “Clean Filter” reminder that appears after each cycle is finished and will stay on the display until the next load is run. This is a reminder message (not sensor based) and appears on the display even if the lint filter has been cleaned. It cannot be disabled.