Menu Close

Why is my Moen kitchen faucet dripping?

Why is my Moen kitchen faucet dripping?

If your Moen kitchen faucet is leaking from the spout, the cartridge isn’t sealing water. The problem could be a damaged cartridge or worn seals. To access the cartridge, some disassembly is required. Turn off the water valves under the sink and open the faucet to relieve water pressure.

Do the Moen faucets have O rings?

In Moen faucets, there is a cartridge with a rubber O ring. If the O-ring becomes damaged, the faucet may begin to leak. Replacing the part isn’t difficult and only needs a few minutes of your time.

How do you fix a leak at the base of a Moen kitchen faucet?

Moen Faucet Leaking At Base: How to Repair It

  1. Shut the Water Supply Off. The water supply can be found beneath the sink.
  2. Observe the Moen Faucet Structure.
  3. Take Out the Spout Retainer.
  4. Remove the O-Ring.
  5. Replace the O-Ring.
  6. Reattach the Spout Retainer.
  7. Turn Water Supply Back On.

How do you fix a leaky Moen kitchen faucet?

Leaky Moen Kitchen Faucet Repair Step 1: Obtain Parts and Tools. One little known secret is that Moen guarantees its parts for life. If you ever have an… Step 2: Handle and Dome. To remove the handle, flip open the little red/blue plastic nib on the side of the handle (see… Step 3: Handle

Can you replace the O ring on a Moen faucet?

You could have these reground, but it’s easier and less expensive to simply replace them. If a Moen single-handle kitchen faucet is leaking from the handle, or you see water dripping onto the sink deck, the O-rings around the base of the spout are worn.

What is the function of the cartridge on a Moen faucet?

This part is responsible for controlling the water flow. If a faucet is not shutting off properly the reason is usually the cartridge. Single handle faucets will contain one cartridge and dual handle faucets have two. There are a variety of cartridges used in Moen faucets, these are not interchangeable with each other.

How do you remove the cap on a Moen water softener?

The cap usually bears the Moen logo. Loosen the set screw with a 1/8-inch Allen wrench and pull off the handle. It should come right off, but if it doesn’t, a few light taps with a hammer should loosen the scale that is binding it. Unscrew the retaining nut holding the cartridge using tongue and groove pliers.