Which command you should type at boot prompt to start Linux installation via NFS?

For example, consider a system connected to an NFS server through the eth1 device. To perform a kickstart installation on this system using a kickstart file from the NFS server, you would use the command ks=nfs::/ ksdevice=eth1 at the boot: prompt.

Table of Contents

What is the different methods to publish Kickstart file?

Kickstart installations can be performed using a local DVD, a local hard drive, NFS, FTP, HTTP, or HTTPS.

What is the name of the default Kickstart file that is created after installing an RHEL server?

anaconda-ks.cfg
Your choices for installation are automatically stored in a Kickstart file named “anaconda-ks. cfg“. Whenever you install an operating system on Fedora, CentOS, RHEL, or another Red Hat-based Linux distribution, “/root/anaconda-ks. cfg” is the location of this Kickstart file in the root user’s home directory.

What is the different method to publish Kickstart file in Linux?

To use a kickstart file to install Red Hat Enterprise Linux, you must: Create a kickstart file. Create boot media for the kickstart file….You can run a kickstart installation from any of these sources:

DVD drive: ks=cdrom:/directory/ks.
Hard Drive: ks=hd:/device/directory/ks.
Other Device: ks=file:/device/directory/ks.

How do I run a kickstart in Linux?

How Do You Perform a Kickstart Installation?

Create a Kickstart file.
Make the Kickstart file available on removable media, a hard drive or a network location.
Create boot media, which will be used to begin the installation.
Make the installation source available.
Start the Kickstart installation.

How do you set up a Kickstart server?

Step 1: Setup Installation Repo.
Step 2: Install and Configure TFTP Server.
Step 3: Setup PXE boot server.
Step 4: Install and Configure DHCP server.
Step 5: Configure kickstart server.
Step 6: Install and Configure NFS.
Step 7: Perform VirtualBox PXE Boot Installation.

How do I set up a Kickstart server?

How do you set up a kickstart?

Make the Kickstart file available on removable media, a hard drive or a network location. Create boot media, which will be used to begin the installation. Make the installation source available. Start the Kickstart installation.

How do I use Kickstart?

To use Kickstart, you must:

Create a Kickstart file.
Make the Kickstart file available on removable media, a hard drive or a network location.
Create boot media, which will be used to begin the installation.
Make the installation source available.
Start the Kickstart installation.

What is an anaconda Kickstart installation?

This is similar to a manual installation, where anaconda displays a message and waits for the user to press a key before rebooting. During a kickstart installation, if no completion method is specified, this option is used as the default.

How do I reboot a Windows installation using KickStart?

Normally, kickstart displays a message and waits for the user to press a key before rebooting. The reboot option is equivalent to the shutdown -r command. Specify reboot to automate installation fully when installing in cmdline mode on System z. For other completion methods, refer to the halt, poweroff, and shutdown kickstart options.

How do I install the Kickstart configurator?

The Kickstart Configurator program is installed from a yum repository using the following command as the root user. The Kickstart Configurator program allows you to answer most of the questions asked during an interactive installation process.

Why is red hat asking me which installation I have installed?

If more than one Red Hat Enterprise Linux installation exists on the system on different partitions, the installation program prompts the user and asks which installation to upgrade. All partitions created are formatted as part of the installation process unless –noformat and –onpart are used.