How do I reset my DCS 5222l?
Step 1: With the unit on, use a paper clip to press the reset button inside the hole on the back on the unit labeled Reset. Step 2: Hold the button down for 10 seconds and release. Note: Do not unplug the power during this procedure. Step 3: The unit will then reboot.
How do I factory reset my Dlink device?
Step 1: Make sure your device is connected to a network and the status light is solid green. Step 2: Please use an unfolded paperclip to press and hold the RESET button for at least 20 seconds while your device is plugged in. Step 3: Please wait 60 seconds for the device to reboot.
How do I reset my IP on my PTZ camera?
Press and hold the reset button below the camera module for at least 10 seconds. While still holding the reset button, disconnect and reconnect the Ethernet cable. Hold the button for 15 seconds before releasing. LIMITATION: Not all PTZ cameras have a manual reset option.
How do I factory reset my camera?
For cameras with a Reset button:
- Locate the RESET button on the camera.
- Use a pointed object (like a ballpoint pen) to press and hold the RESET button for 2-3 seconds.
- After two to three seconds, release the RESET button.
How do I reset my Dlink DVR?
- A:
- To perform a factory reset, please follow the steps below. Step 1: With the unit on, place a paper clip into the hole on the back of the unit labeled Reset. Step 2: Hold paper clip down for 10 seconds and release. Step 3: The unit will reboot on its own. Once the WLAN light stops blinking, the unit is reset.
How do I reconnect my Dlink camera to WIFI?
Step 1: On your smartphone or tablet, make sure you turn on Bluetooth and connect via Wi-Fi to the wireless router you want to connect the camera to. Step 2: Launch the mydlink Lite app on your device. Step 3: Tap Add a New Camera. Step 4: On the QR Code Setup screen, tap Yes.
How do I fix my IP address on my Dlink router?
Step 1: Open your web browser and enter http://dlinkrouter or http://dlinkrouter.local or http://192.168.0.1 into the address bar. Step 2: The default username is Admin and the password is blank (nothing). Click Login. Step 4: Under Router Settings, type in the router´s new IP address and subnet mask.