Can I use an amp with factory stereo?
Another popular way to connect an amplifier to a factory radio is to use something called a line output converter. It connects to the factory radio’s speaker wires and converts the speaker-level signal to a preamp-level signal. This lets you use RCA cables to run that signal to your amplifier.
Can you hook an amp up to a factory car stereo?
Usually, you’ll be installing a 4-channel amplifier with speaker-level inputs. The best way to connect it to a factory system is to tap into the stereo’s speaker outputs for the amp’s input signal. Then send the amp’s outputs back to the stereo’s harness, and on to the speakers through the factory wiring.
Do I need RCA cables for my amp?
What wiring and accessories do I need? Car amplifiers don’t come with any wiring included. You must supply the amp’s power and ground wiring, an inline fuse, a remote turn-on wire, RCA cables, and speaker wires.
Can I run an amp to my factory stereo?
Can you add an amplifier to a factory stereo?
Adding an amplifier to a factory stereo often requires running a lot of new speaker wire — from the stereo to the amplifier and then from the amp to the speakers. This can feel like an impossible nightmare. Fortunately, we have a way to make it a little easier.
How do I connect my amp to my car stereo system?
The best way to connect it to a factory system is to tap into the stereo’s speaker outputs for the amp’s input signal. Then send the amp’s outputs back to the stereo’s harness, and on to the speakers through the factory wiring.
How long does it take to install a car amplifier?
When you connect your car factory radio with a suitable amplifier. You will have a decent audio system that can deliver excellently on your desired performance With the necessary tools and adequate understanding of the project, it takes between 1-4 hours on average to complete the amp installation on your vehicle.
How do I connect my speakers to my amplifier?
If your amplifier has an internal Hi Lo you will need to cut your speaker wires and attach them to the amplifier input wire harness listed in the parts list at the top of the page. Run those wires to the amplifier and connect them into the input section of the amplifier