How much does helical piers cost?

How much do helical piers cost? The cost of a helical pier depends on the design, size, and weight of the structure and the adjacent soil conditions. Due to these many variables, an installed helical pier can range in price from $15-$30 per foot. So, a typical 20-foot helical pier can cost between $300 – $600 each.

Table of Contents

How much weight can a helical pier support?

500 tons
Helical piles are capable of holding more than 500 tons of weight.

How many helical piers do I need?

Assuming each pier has a bearing area of 1.6 sq ft (two helices of 12” diameter each), there must be a minimum of 405,000 lbs/12,000 psf divided by 1.6 ft2/pier, or 21 piers around the perimeter. For a safety factor of 2, there should be 42 piers.

Are helical piers better than concrete?

Using Helical Piles instead of Concrete Benefits: Helicals are a permanent foundation solution, that will last you a lifetime. The installation is clean and no excessive excavating is needed. Helical piles can be used for any size project. Helicals can be built upon the same day, there is no waiting time for curing.

How long does it take to install helical piers?

How long does it take to install a helical piers? Installation process of helical piers is very quick as as much as 30 helical piers can be installed in a single day for new foundation.

How much does it cost to install helical piles?

How Much Does The Average Helical Pier (Pile) Installation Job Cost? The average cost of installing helical piers ranges from $48 to $143 per foot. Therefore, for standard installations where 21-foot long piles are used, the price will be between $1,000 and $3,000 per pier.

Are helical piles cheaper than concrete?

Many homeowners assume that screw piles are much more expensive than poured concrete foundations, which isn’t always the case. Many factors impact the cost of installation, but in some instances, the price difference between screw piles and poured concrete for a given job can be nominal!

How deep can helical piers go?

between 10 to 25 feet
How deep can helical piers be installed? Most are installed between 10 to 25 feet below the soil but may be required to extend deeper if the required torque is not met. We have had some piles installed as deep as 100 feet.