How can I Serial APC UPS?

Connect to the UPS/device serial port using the correct APC configuration cable….9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control.

Table of Contents

Apply the port settings to establish the connection.
Press enter 3-5 times to display the username prompt.
Use the default username and password of “apc”.

Can you ssh into a UPS?

Tutorial APC UPS – Enable SSH Open your browser and enter the IP address of the APC UPS. On the login screen, use the default username and default password. After a successful login, you will be sent to the APC UPS Dashboard. Select the SSH check box and click on the Apply button.

What is the default IP address of APC UPS?

192.168.2.66
The default IP address is 192.168. 2.66 with a subnet mask of 255.255. 255.0.

How do I disable Telnet on APC UPS?

Remote access to the command line interface Enabling SSH disables Telnet. To enable or disable these access methods, use the Web interface. On the Configuration menu, select Network – Console.

How do I telnet to APC UPS?

On the login screen, use the default username and default password. After a successful login, you will be sent to the APC UPS Dashboard. Access the Configuration menu, access the Network menu, access the Console menu and select the Access option. Select the Telnet check box and click on the Apply button.

How do I reset my apc username and password?

Press the Reset button a second time immediately while the LED is rapidly flashing – which will cause the LED to then go off – in order to reset the User Name and Password to their defaults temporarily (the default User Name and password are both apc).

How do I reset my apc management card?

Locate the APC network management interface on the back of your APC UPS. Press the reset button for 20 seconds. Wait for the network led change to the orange color. The APC UPS network management interface will reset its configuration back to the factory default.

How do I factory reset my apc PDU?

Resetting APC AP7920 PDU

Press and hold the reset button for about 10 seconds.
The status light should blink rapidly.
Release the reset button then press it again for about a second.
The light should go orange.
After about 20 seconds the reset will complete and the device will have booted.