Menu Close

How much is a water pump for a Dodge Stratus?

How much is a water pump for a Dodge Stratus?

The average cost for a Dodge Stratus water pump replacement is between $722 and $831. Labor costs are estimated between $418 and $528 while parts are priced at $303.

How much does it cost to replace a water pump in a 2005 Dodge Stratus?

Taking all these points into consideration, you can expect to pay anywhere from $375 to $787 (including parts and labor). Of course, shopping around to get a few quotes is your best bet to get the best deal. For more water pump information, read our article Does My Car Need a New Water Pump?

How much is a water pump for a 2004?

Where is water pump on Dodge Stratus?

The water pump is behind the timing cover. Esssentially – you need to remove (replace) the timing belt to replace the water pump. This is not a very easy do-it-yourself job unless you are an experienced technician.

How long does it take to change water pump on a Dodge Stratus?

This is not a very easy do-it-yourself job unless you are an experienced technician. Serious damage could result from removing a timing belt without the proper know-how. Also, the labor guide calls for 5 hours – so it’s not a quick and easy job, either.

Does a 2004 Dodge Stratus have a timing belt?

Rotate the top plate CLOCKWISE until there is enough slack in timing belt to allow for removal. Remove timing belt. CAUTION: If timing belt was damaged due to incorrect tracking (alignment), the belt tensioner pulley and bracket must be replaced as an assembly.

What a bad water pump sounds like?

If you hear a high-pitched, whining sound that increases as you accelerate – it could indicate a faulty water pump. These sounds are caused by a loose belt and the belt becomes loose when the pulley is loose or the bearings are wearing out.

What noise does a bad water pump make?

Whining or Groaning Noise A whining or groaning noise usually means that either a drive belt is loose, or the water pump pulley is bad. It may surprise your customer that a pulley could fail, but it does occasionally happen. Pulleys have been known to fail due to rust, which can cause cracking between their bolt holes.