How do I reset my Balboa spa?
At 107¡F (approximately 41.7¡C), the spa should automatically reset. If spa does not reset, shut off the power to the spa. Standby Mode has been activated by pressing a button combination on the user panel. Press any button to leave Standby Mode and return to normal operation.
What mode should my hot tub be?
Economy is a good setting for those who use the hot tub daily. The drop in temperature fluctuates during the year from minor or no temperature falls in the summer, to larger drops in the coldest part of winter.
What does eo2 on lazy spa mean?
Is there an E02 error code displaying on your Lay-Z-Spa pump? This means your Lay-Z-Spa pump is experiencing a water flow issue.
Why is the blue light flashing on my hot springs hot tub?
Should your blue light be blinking, it typically means your high-heater thermostat tripped. In this case, we suggest disconnecting power for at least 30 seconds to reset a higher heat limit. Should this not work, checked for clogged filters. If the problem continues call for service.
Should a hot tub be left on all the time?
One of the most common questions our team gets asked is “should I leave my hot tub on all the time?” Quite simply, the answer is yes… your hot tub is designed to be left switched on constantly and works best when it is left on all the time. Your hot tub is at it’s most efficient if left to run 24/7.
Should I put my hot tub in economy mode?
Since the heater isn’t running for long periods of time, the water temperature can vary quite a bit. This makes it less than ideal if you are planning on using the hot tub. For this reason, it’s best to only run economy mode when you’re not going to be home for 2-3 days or more.
What voltage does the vs501z controller run on?
This controller operates on 110/220V (220V requires 4-wire service). The VS501Z controller is equipped with M7 technology which allows the heater to be mounted either on the suction or discharge side of the pump. Circ Pump Circuit, 110/220V, 2A Max (24Hr when activated, Requires 25 GPM)
Is the Balboa spa controller vs501z field configurable?
This Balboa Spa Controller VS501Z Kit with 5.5KW Heater is field configurable. Internal component circuits can be setup to work with your existing pump, blower and ozone.
What are the error codes on a hot tub?
1) Hot Tub Error Codes (Alphabetical) * * * (3 flashing dots under temp displa Flow/Pressure switch either Open or Clos * * * (as above, & red LED lit up on boa High Limit Fault – – – , – – – ‘Watchdog’ – 48C reached, electronic fau – 01 Hi-Limit fault – 02 Temp sensor fault