How do I reset my Vaillant boiler Ecotec plus 824?
The reset button is located on the boiler’s display and will likely show a flame with a line crossed through it. You will only need to press the reset button for three seconds before the boiler resets and the display screen should change.
Why am I not getting hot water from my Vaillant boiler?
The most common reason for a lack of hot water is a boiler fault. If your boiler is faulty you should call a GSR engineer to look into it for you. Other causes include low or high water pressure, an interruption of your power supply or a piping issue. It could be an issue with you timer.
How do I turn on the heating on my Vaillant boiler?
Turn the boiler ON by turning the ON/OFF control (5) from the ‘0’ position to the ‘I’ position. The radiator temperature control (2) sets the maximum radiator temperature. Check that the remote programmer is in an on setting (see separate programmer instructions) and check that the room thermostat is calling for heat.
What temperature should the hot water be set at on a combi boiler?
60 degrees
Your boiler controls explained To maximise efficiency, we recommend setting your radiator dial to 75 degrees and your hot water to 60 degrees. Once you’ve got your boiler running at the optimal temperature, you’ll want to set the timer for when you need heating the most. With a combi boiler, hot water is on demand.
Why is my heating working but I have no hot water?
In the case that your radiators are heating up but there’s no hot water coming from the taps, then the most likely cause is a broken diverter valve. Combi boilers are fitted with a diverter valve, that opens and closes depending on whether hot water needs to be sent to the radiators or taps.
Why is my boiler working but I have no hot water?
If your heating is working but you have heating but no hot water or vice versa, it is likely to have become stuck. You will need to contact a Gas Safe engineer to solve a problem with your diverter valve.
How do I turn on my Vaillant Ecotec plus heating?
Ensure the electrical supply to the boiler is turned on. This may be from a switched socket or a fused spur located near the boiler. This switch should be left ON continuously to operate the boiler. Turn the boiler ON by turning the ON/OFF control (5) from the ‘0’ position to the ‘I’ position.
What temperature should my boiler be set at?
As a rule, setting your heating control to 75 degrees should be sufficient to give you a perfectly warm house, while also allowing your boiler to run as economically as possible. Once this is set, you shouldn’t need to adjust it.
How many manuals are there for Vaillant Ecotec plus 824 boiler?
User Manuals, Guides and Specifications for your Vaillant ecoTEC plus 824 Boiler. Database contains 5 Vaillant ecoTEC plus 824 Manuals (available for free online viewing or downloading in PDF): Instructions for installation and servicing, User manual manual .
How do I contact a Vaillant boiler installer?
If you are unable to contact your installer, phone Vaillant Service Solutions: 0870 6060 777 3.2 Intended use Vaillant ecoTEC boilers are state-of-the-art appliances which have been constructed in accordance with recog- nised safety regulations.
Where is the type plate of the Vaillant Ecotec attached?
The type plate of the Vaillant ecoTEC is attached at the factory to the bottom of the appliance. 2 Safety 2.1 Setup and adjustments
How does the Ecotec plus appliance work?
The ecoTEC plus appliance is fitted with a digital infor- mation and analysis system. This system provides infor- mation on the operating status of your appliance. During normal operation, the display (1) shows the cur- rent heating flow temperature (in this example 45 °C).