How tall is a 50 gallon power vent water heater?

T&P Relief Valve

Table of Contents

Type:	Short
Height:	50 3/4″
Height w/Draft Hood:	60 1/8″
Diameter:	24″
Width:	24″

How do you read a Rheem serial number?

Quick answer: For most Rheem models and all those made recently, the serial number begins with a letter followed by 9 numbers. The first two numbers after the letter represent the week of the year, 1 through 52. The second two numbers (numbers 3 and 4) are the year.

How do I tell what year my Rheem water heater is?

The third and fourth numbers in the serial number, usually after several letters, is the year of manufacture of a Rheem water heater.

How much does it cost to have a hot water heater drained?

between $80 and $100
The cost of flushing a water heater can vary quite a lot depending on the area, the quality of the plumber, and the type of water heater. Generally, for most standard water heaters, a flush will cost between $80 and $100.

How much does it cost to install a 50 gallon water heater vent?

The national cost range for installing a water heater is $800 to $2,500, with most homeowners paying $1,200 to install a whole-house 50-gallon tank unit for a 4 to 5-person household….Water Heater Installation Cost by Type of Vent.

Type	Average Costs (Installed)
Direct Vent	$350 – $4,000
Power Vent	$1,050 – $5,000

Can you install a power vent on an existing water heater?

Power vents simplify a gas hot water heater installation Reduce high electric bills by replacing an electric water heater with a natural gas or propane heater, then reduce installation costs by installing a power-vented model that can be easily vented out a sidewall.

How do I decode a Rheem model number?

You can determine the size in tons of your Rheem HVAC system by examining the model number on the data sti at the side of the a/c condenser (outdoor unit). Look for the second cluster of digits of the model number. It will have a number divisible by 6 or 12, and represents the nominal BTU of the system in thousands.