How much HP does 383 stroker put out?
The 383 stroker engines have been reported to achieve 330 horsepower with 410 foot-pounds of Torque, 395 horsepower with 410 foot-pounds of Torque and 395 horsepower with 410 foot-pounds of Torque.
Who makes FiTech fuel injection?
To those hold-outs with their head buried in the sand, we’ve got one thing to say: you better check out FiTech. FiTech, a new American company based in Riverside, California, is the brainchild of Ken Farrell and Jeremy Schmidt.
How much is a 383 stroker?
The HP94 Chevy 383ci stroker from ATK is being offered by Jegs at the low price of $3,993.99, but is found throughout a range of big-box stores, so it might pay to shop around some, as is the case with any large-volume crate engine commodity like a Chevy 383ci stroker.
Does FiTech add horsepower?
FiTech has designed EFI systems that work on engines reaching up to 1,200 horsepower. These EFI systems can be used in dual quad, nitrous, and boosted engines as well as your standard single 4 barrel intake.
Can you run nitrous with FiTech?
If the ECU is to be in control of the relay that drives the solenoids, set this accordingly. If the ECU is used with a nitrous system, set this accordingly. If the signal that tells the ECU to enable nitrous is a +12V signal, or a grounding signal, set this value accordingly.
What is the difference between the Holley sniper and Terminator?
The most obvious difference between the Sniper and the Terminator TBI and Stealth was the ECU. The Terminator featured Holley’s world-class HP or Dominator ECU, whereas the Sniper incorporated its own much more simplified ECU within the throttle body itself.
How much will it cost to make a 383 Stroker?
To make a 383 out of it you’ll need it bored .30 over, usually around $100 to bore and hone it. Then you’ll need a new crankshaft with a 3.750″ Stroke, and you’ll also need the block clearanced for the stroker crank which is about $150 around here. I’m sure some of the older guys could correct me if I’m wrong.
What is the best transmission for a 383 Stroker?
TH400. This is an improvement over the TH350 and is more expensive than that model too.
What is the bore and stroke of a 383 Chevy?
The chevy stroker 383 is constituted with a stroke of 3,75 inches and a bore of 4.03 inches compared to the crate motor chevy 350, which has a stroke of 3.48 inches and a bore of 4.00 inches. The 383 stroker engines can draw up to 383 cubic inches of fuel in one cycle, from which it got its name, and now it has taken the place of the industry
How much HP does a 383 stroker make?
How much horsepower does a supercharged 383 stroker make? After installation of the ProCharger P-1X and blow-through carb, the supercharged 383 pumped out 641 hp at 6,500 rpm and 566 lb-ft of torque at 4,900 rpm. Stepping up the boost to 10.6 psi resulted in peak numbers of 679 hp and 599 lb-ft of torque. Can I put a LT4 supercharger on a LT1?