Why does my belle mixer keep stopping?
A common cause for the machines to stop running at this point could be that the motor fan is broken or missing blades. This fan is designed to take the warm air away from the motor, so with this element damaged after a few minutes of running the motor can overheat and shut down. These fans are available separately.
Why is my cement mixer not working?
Broken Belt If you find your motor is running but the drum isn’t rotating, it’s likely that the belt has broken. This is very common and is simply caused by lots of use. Whether your mixer is electric powered, or petrol powered, you can remove the side cover on the machine and replace the belt with ease.
What does a capacitor do on a cement mixer?
The starter capacitor and winding are used to give a huge current boost to the main winding in the motor when starting, this gives inertia to the heavy mixer barrel but is only needed to get it going.
Do Belle electric mixers need oil?
Yes all the mixer range comes complete with oil already installed.
Where are Belle cement mixers made?
the United Kingdom
Manufactured in the United Kingdom! Belle’s exceptionally popular mixer continues to set the standards by which all mini concrete mixers are judged.
What oil do you put in a Belle mixer?
The grade of oil should be 10W 30 mineral oil.
What oil do you put in a Belle cement mixer?
What engine is in a Belle mixer?
Honda GX120 Petrol Engine
Belle Minimix 150 Cement Mixer With Honda GX120 Petrol Engine.
Who owns Belle mixers?
the Altrad Group
At the start of 2009 the Altrad Group completed the purchase of the Belle Group, thus ending over 50 years of independent ownership by the Blackhurst family.
Who makes Belle cement mixers?
Altrad Belle Construction
Altrad Belle is the brand behind the quintessential orange cement mixers seen on construction sites up and down the country. They have been making portable cement mixers since the 1950s, when Belle’s founder designed his first portable site mixer.
Why is my cement mixer leaking oil?
When a machine leaks oil, you know it’s bad news. It’s no different when it comes to industrial mixers. Our Service Team says when mixers are sent to us because they’re leaking oil, it’s usually because the seal is worn.
If your Belle Minimix 150 runs when it is first switched on, it suggests that the switch and the capacitor are working. A common cause for the machines to stop running at this point could be that the motor fan is broken or missing blades.
How do you service a cement mixer?
Cleaning the Drum Drum maintenance is relatively straightforward, simply switch the mixer on and pour some water inside, once it has turned several times, empty the dirty water out into a bucket. A pressure hose can also be used on the inside of the drum to clean off any excess concrete.
What oil goes in a cement mixer?
SAE 10W-30
SAE 10W-30 is recommended for general use. Other viscosities shown in Table 1 may be used when the average temperature in your area is within the the indicated range. 1. To add motor oil to the the engine crankcase, place the mixer on secure level ground with the engine stopped.
Where is the capacitor located on an electric motor?
The starting capacitor might be atop the motor under a single domed cover if the motor uses a combined start/run capacitor. The run capacitor will usually be attached to the exterior of the motor under a bulged cover such as in our photo below. This motor has two external capacitors: start & run (yellow arrows).