What is the default IP address of Cisco 2960?

What is the default IP address of Cisco 2960?

172.20. 20.84, both devices are in the same network. 10.0.

How do I configure the management port on a Cisco 2960 switch?

How to configure the port

1. For 2960X. interface Fa0 description MGMT Port ip address x.x.x.x 255.255.255.0 no shut ip default-gateway 0.0.0.0 0.0.0.0 (default gw)
2. For 3650, 3850.
3. Configure AAA authentication.
4. Configure VTY access-list.
5. Configure NTP server.
6. Configure Netflow.

How do you initially configure a Cisco switch?

How to configure Cisco switch?

1. Initial command prompt “Switch>” appears on the screen.
2. Type “enable” next to it and press “Enter”.
3. This will take you into the “EXEC” mode, also known as the Global Configuration mode.
4. Go into configure mode using configure terminal.
5. Enter the configuration commands one per line.

What is the difference between management port and console port?

A management port can be used for remote management and configuration of a networking device, where as the Console Port can be used, in conjunction with a console server, such as Lantronix SLC 8000, to implement a separate dedicated network to access the network devices in case the primary network goes down.

How do I connect my Ethernet management port?

Connecting to the management port

1. By default, the management interface is set to automatically obtain an IP address from a DHCP server, and SSH support is enabled.
2. Use an Ethernet cable to connect the management port to your network.
3. Use an Ethernet cable to connect your computer to the same network.

How do I enter Cisco config mode?

To enter global configuration mode, enter the configure command. Global configuration From privileged EXEC mode, enter the configure command. To exit to privileged EXEC mode, enter the exit or end command, or press Ctrl-Z. To enter interface configuration mode, enter the interface configuration command.

How do you configure a basic switch?

How to configure a network switch

1. Step 1: Connect to the console.
2. Step 2: Set a management IP and default gateway.
3. Step 3: Set hostname and domain name.
4. Step 4: Set logins on VTY lines and console port.
5. Step 5: Set Privileged EXEC password.
6. Step 6: Enable SSH.
7. Step 7: Create VLANs.
8. Step 8: Add access ports to a VLAN.

How do I connect a Cisco switch to an Ethernet cable?

Step 1 Connect one end of the yellow Ethernet cable to an Ethernet switch port on the router. Figure 3-2 shows a Cisco 888W router connected to an Ethernet switch. Step 2 Connect the other end of the cable to the available port on the Ethernet switch to add additional Ethernet connections.

What is my Cisco username?

The default username is cisco. The default password is cisco.