How do I set my decoder to factory settings?
Press the blue “DStv button” on your remote control. Then use the right arrow on the remote control to go to “Settings“. Use the down arrow to go to “System Settings“. Scroll down using the down arrow to select “Reset To Factory Default” then press “OK” on your remote control.
Why is my DStv decoder showing orange green and red lights?
If your dstv decoder is refusing to start properly after loadshedding and is showing the orange light and probably blinking red and green, here is what you can do. Press and hold the power button on the decoder for about 30 seconds. The lights will blink and the device will load and start properly.
What happens when you reset your decoder to factory settings?
What Happens When You Reset Your DStv Decoder? When you reset your DStv decoder, all the previous setup on your receiver are restored to the default settings. This means if you have made any changes to your decoder menu, then all those settings will be deleted and restored to the factory settings.
How do I fix my decoder signal?
What to do when your decoder loses signal
- Step 1: Check whether the cables connecting the decoder are in place.
- Step 2: Try rebooting the decoder.
- Step 3: Visually check your dish.
- Step 4: Examine the status of the Low-noise Block downconverter (LNB)
How do I get rid of the orange light on my decoder?
Since the light on DStv decoder comes up when you have an unread notification, the simplest way to fix it is by reading them. Open all these messages one by one and read the important information they have. Once you are done, press the back button on your remote to exit the mail section.
What causes the decoder to have an orange light?
Whenever you see an Orange/Yellow light on your DStv decoder, it means you have unread mail messages from DStv.
How do you fix a decoder?
First, unplug the power cable to your decoder and let it drain for around ten minutes. Second, disconnect anything connected to it, such as memory sticks and the smart card. Finally, reboot the decoder with all these items disconnected, and it should respond well and boot in time.
What causes no signal on decoder?
The reason your DStv says no signal is because there is an error in the DStv installation. This is caused by either a misaligned satellite dish, a faulty LNB, an improperly connected F-connector plug, loose cables or incorrect decoder settings on the LNB type.
What causes orange light on decoder?
Can decoder be repaired?
Yes, any DStv decoder that has a fault can be repaired at the nearest Multichoice service center. Sometimes you will be given a decoder to be used while yours is being repaired, depending on your decoder’s fault.
Why is my decoder flashing an orange light?
Why is my decoder not responding to my remote?
You may also need to press the CABLE button at the top of the remote to direct the signal to the receiver and then try a few functions (Guide, Menu/Settings, etc.) to see if it is only certain buttons that do not work. Failing this, you can try resetting your receiver. Unplug your receiver and wait 15 seconds.