How do you replace the waste ink tank on a Pitney Bowes dm400c?

How do you replace the waste ink tank on a Pitney Bowes dm400c?

This process can be performed without the replacement waste pad installed, so that you can run your meter until you receive and install the replacement waste pad.

1. Press Menu.
2. Press Page Down.
3. Select Maintenance.
4. Select Replace Waste Tank.
5. Select Ok, I understand.
6. Press Yes, tray is replaced.

What does waste ink tank full mean?

A Waste Tank Full or Ink Waste Tray Full message on your meter means your ink system requires maintenance. “Waste Tank Full” or “Ink Waste Tray Full” messages on your meter mean your ink system requires immediate maintenance. Your mailing system may not be usable until your waste tank (waste tray) is replaced.

How do you replace the waste tank on Pitney Bowes?

Waste Tank Full:

1. The Waste Ink Tank Full Replacement Required message displays.
2. Press the Options key.
3. Press Page Down twice.
4. Select Advanced Features.
5. Select Maintenance Mode.
6. Select Printer Maintenance.
7. Select Replacement.
8. Select Replace Ink Tank. You’re prompted to open the cover to start the replacement.

How do you change waste tank on Pitney Bowes dm300c?

Select Menu. Press Page Down. Select Maintenance. Select Replace Waste Tank.

How do you change a waste pad?

1. Squeeze your tray handles and pull the waste pad tray assembly out of the right side of your meter.
2. Using rubber gloves or a paper towel, lift out your plastic waste tray holder.
3. Place your new waste tray in the holder.
4. Slide your waste pad tray assembly back into the right side of your meter.

How do you fix an ink absorber that is almost full?

Press and hold the “Power” button and reconnect the power cord. When the printer comes on, release the button. Wait five seconds and push the “Power” button again. This resets the printer’s internal memory and overrides the “Ink Absorber Full” error code.

How do you empty a waste ink tank Pitney Bowes dm100i?

Select the Diagnostics screen on the meter display. Select PM Maintenance. Press Page Down until Clear Waste Tank, Clear Waste Count, Reset Waste Count, or Reset Waste Tank displays. Press Yes/Enter.