How do I setup my HP MSM720 wireless controller?

Initial Setup E-MSM720 Wireless Controller

Table of Contents

The controller sets itself up on 192.168.
Connect to https://192.168.1.1.
The MSM720 Default username and password are both admin.
Accept the EULA > Skip Registration > Set country > Save > Set the new password > Save.
Configure Initial Controller Settings > Start.

How do I reset my HP MSM720 controller?

To reset the controller to its factory default configuration:

Using a paperclip, press and release the Reset button.
Immediately press and hold the Clear button until the LEDs above the Clear button blink three times, then release the Clear button.

How do you use the Hewlett Packard controller?

To initially configure the controller:

Configure your computer to use a static IP address in the range 192.168. 1.2 to 192.168.
Connect network cables as follows:
Power on the controller and wait approximately 90 seconds until the Test LED turns off.
Follow the Configure initial controller settings workflow.

How do I factory reset my Aruba 7010?

(controller) *#exit User: admin Password: (controller) *#write erase All the configuration will be deleted and the controller will be reloaded. Press ‘y’ to proceed : [y/n]: y Write Erase successful System will now restart!

How do I access my Aruba controller?

For a controller that is up and operating with layer-3 connectivity, configure the following to set the controller as local:

Navigate to the Configuration > Network > Controller > System Settings page.
Set the Controller Role to Local.
Enter the IP address of the master controller.

How do I reset my Aruba network?

To reset a n IAP, perform the following steps:

Power off the IAP.
Press and hold the reset button using a small and narrow object such as a paperclip.
Power on the IAP without releasing the reset button. The power LED flashes within 5 seconds indicating that the reset is completed.

How do I access HP Smart Array configuration utility?

Open the browser on the remote server. The System Management Home Page opens. 3. Click Array Configuration Utility on the left-hand side of the screen.

How do I open the array configuration utility on HPE ProLiant server?

ACU is now available as an embedded utility, starting with HP ProLiant Gen8 servers. To access ACU, use one of the following methods: If an optional controller is not installed, press F10 during boot. If an optional controller is installed, when the system recognizes the controller during POST, press F5.

How do I make my Aruba access point default?

Resetting a Remote AP or Campus AP to a n Instant AP

Turn off the Instant AP.
Press and hold the reset knob using a small and narrow object such as a paperclip.
Turn on the Instant AP without releasing the reset knob. The power LED.
Release the reset knob. The Instant AP reboots with the factory default settings.

How do I access HPE Smart array?

During the initial boot:

To modify the server configuration ROM default settings, press the F9 key in the ProLiant POSTscreen to enter the UEFI System Utilities screen.
If you do not need to modify the server configuration and are ready to install the system software,press the F10 key to access Intelligent Provisioning.

How do I setup my HP MSM720 wireless controller?