Why do my running lights work but not my brake lights?
The most common reason why your tail lights are not working but brake lights are is due to a bad or wrong type of light bulb installed. It can also be caused by a blown fuse, bad wirings, or corroded sockets or plugs. A faulty control light switch could also be to blame.
How much is a brake light switch for a Hyundai Sonata?
The average cost for a Hyundai Sonata brake light switch replacement is between $58 and $73. Labor costs are estimated between $38 and $48 while parts are priced between $20 and $26. This range does not include taxes and fees, and does not factor in your specific model year or unique location.
Are there any recalls on Hyundai Sonatas?
2021 Hyundai Sonata Recall Hyundai Motor America (Hyundai) is recalling certain 2020-2021 Santa Fe, 2021 Sonata, and Elantra vehicles. During manufacturing, the windshield may not have been properly bonded to the vehicle, allowing it to detach in a crash.
Do brake lights have a fuse?
Like all fuses, the brake light system fuse can be found in the power distribution center, which is under the dashboard or tucked away underneath the hood. Never heard of the power distribution center? It’s just the technical name for a fuse box.
Can a bad turn signal switch no brake lights?
Turn signal switch The brake lights in some vehicles are powered through the same circuit that powers the turn signal light. If this is the case for your car and the turn signal light isn’t working, chances are the brake lights aren’t either.
Does the brake light switch have a fuse?
Like all fuses, the brake light system fuse can be found in the power distribution center, which is under the dashboard or tucked away underneath the hood.
How do I test a brake switch?
Place the sensor on just one of the two wires and hold the brake pedal down as you do so. Then test the other wire. If power is connected and the switch is working properly, the test bulbs will illuminate. If it doesn’t light up, the brake light switch is faulty and will need to be replaced.
What should I do if my brake light is not working?
If there is a ground wire running to the brake light switch, make sure that it is secured tightly and corrosion free. If you can’t find the ground wire at all, run a jumper wire to substitute for the ground wire. Now test the brake light switch.
Why do my brake lights go out when I brake?
When you press the brake pedal down, it sends this power to the brake lights. This is the most likely failure point. If playback doesn’t begin shortly, try restarting your device.
Will tail lights work if brake lights are burned out?
Please note that tail lights can work even if the brake lights are burned out. It is entirely possible that all the brake lights burned out at the same time. The first thing that you should do if all of the brake lights are not working is check the fuse.